EasyManua.ls Logo

FLYGT 3069 - Page 4

FLYGT 3069
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6.2 Torque values.....................................................................................................................37
6.3 Change the oil....................................................................................................................37
6.4 Service the pump...............................................................................................................40
6.4.1 Inspection.................................................................................................................... 40
6.4.2 Overhaul...................................................................................................................... 41
6.4.3 Service in case of alarm..............................................................................................41
6.5 Replace the D-impeller..................................................................................................... 42
6.5.1 Remove the D-impeller.............................................................................................. 42
6.5.2 Install the D-impeller.................................................................................................. 43
6.6 Replace the F-impeller...................................................................................................... 44
6.6.1 Remove the F-impeller...............................................................................................44
6.6.2 Install the F-impeller...................................................................................................44
6.7 Replace the M-impeller and the cutting wheel..............................................................46
6.7.1 Remove the cutting wheel......................................................................................... 46
6.7.2 Remove the M-impeller..............................................................................................46
6.7.3 Install the M-impeller..................................................................................................47
6.7.4 Install the cutting wheel............................................................................................. 48
6.8 Replace the N-impeller..................................................................................................... 49
6.8.1 Remove the N-impeller..............................................................................................49
6.8.2 Install the N-impeller.................................................................................................. 50
7 Troubleshooting....................................................................................................................... 54
7.1 Electrical troubleshooting.................................................................................................54
7.2 The pump does not start...................................................................................................54
7.3 The pump does not stop when a level sensor is used.................................................. 55
7.4 The pump starts-stops-starts in rapid sequence............................................................56
7.5 The pump runs but the motor protection trips..............................................................56
7.6 The pump delivers too little or no water.........................................................................57
8 Technical Reference.................................................................................................................58
8.1 Motor data.......................................................................................................................... 58
8.1.1 Thermal contacts, opening temperature.................................................................58
8.2 Application limits............................................................................................................... 58
8.3 Minimum permitted liquid level...................................................................................... 58
Table of Contents
2 Flygt 3069 Installation, Operation, and Maintenance Manual

Table of Contents

Related product manuals