Basic Operations
Power on
Follow the steps below to turn on the transmitter:
1. Check to make sure that the batteries are fully charged and installed correctly.
2. Switch the Power Switch to ON position, at the time, the transmitter LED is solid on in
green.
Trims
The ST+ and ST- buttons are for increasing/decreasing the trim value of the CH1, and TH+ and
TH- buttons are for increasing/decreasing the trim value of the CH2. The buzzer will prompt
with tone 1 short beep when the trim is successful. One beep once for a press. when press for a
while, the buzzer will prompt with quick short beep. The buzzer will prompt with 2 short beeps
when the trim is over the mid-point. When the trim is at the end, the buzzer will prompt with
long beep.
D/R adjustment
CH1 D/R can be adjusted by ST+/- button. The adjustment range is 0~120%, the step is 5%,
and the default value is 100%.
CH2 D/R can be adjusted by TH+/- button. The adjustment range is 0~120%, the step is 5%,
and the default value is 100%.
Channel reverse
1. When the steering wheel is in the non-centering state, the channel 1 is reversed by
pressing the REV button, and switch once when the button is pressed.
2. When the throttle trigger is in the non-centering state and the steering wheel is in the
centering state, the channel 2 is reversed by pressing the REV button, and switch once
when the button is pressed.
Note: When the channel reverse takes affect by pressing the REV button, the buzzer will
prompt with 1 beep, and the beeps for CH1 and CH2 are different.
Binding
Follow the steps below to bind with the receiver:
1. Press and hold the BIIND button while turning on the transmitter,the transmitter LED
will flash fast.
2. Put the receiver into binding mode by powering on the receiver, the receiver LED flash
qucikly.
3. The binding process is finished when the transmitter LED stops flashing and is solid on.
4. Check to make sure the transmitter and receiver are working correctly, if there are any
issues or unexpected operation arise, follow the steps above to bind again.
Note: If the transmitter disconnects with the receiver, the transmitter LED will go into three-
flash-one-off state.
To Next Page
Loading...
