Reminder
When the bound receiver is turned off or the receiver disconnects for 2S, the transmitter
will in reminder mode, and prompt this mode by the LED which is in flash-three-one-off
state.
Note: When the transmitter has received the information returned by the receiver, it will exit
reminder mode.
Certifications
Specifications
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Warning: changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
Product Name FMS-G3
Compatible Receiver FMS-R3A
Model Type 1:18 , 1:24 simulation cars or rock cars
PWM Channels 3
RF 2.4GHz ISM
2.4G Protocol AFHDS 2A-BS
Resolution 1024
Maximum Power < 20dBm (e.i.r.p.) (EU)
Antenna Singal internal antenna
Input Power Powered by 4*1.5V AA alkaline batteries
Working Current 120mA/6V
Distance >100m
Online Update No
Dimensions 115.2*75.5*145mm
Weight 113g
Certifications CE, FCC ID: 2A2UNG300
To Next Page
Loading...
