FS-G7P
Digital Proportional Radio Control System
Website
6
4.4 Calibration
The calibration is required in case of data oset of the transmitter due to physical wear in long-term operations. At this
time, we need to calibrate the output data and neutral angle of the traversing steeringwheel, throttle trigger, VR1and
VR2.
The transmitter has been calibrated at the factory. If you need to recalibrate it, please follow the steps below: Please
follow the steps below to perform the settings:
1. Power on the transmitter, enter the system menu, and select the stick calibration function. Follow the prompts to
press the Start key for calibration.
2. Swing the steeringwheel and trigger to the maximum and minimum travel in each direction respectively and then
release them. Turn VR1 to its maximum and minimum travel and then back to the neutral position. Toggle the VR2
left and right repeatedly to the maximum extent for two or three times. Finally, toggle the VR2 back to the neutral
position.
3. Press the return key to exit the calibration interface. The calibration is complete. If the pop-up window indicates
that the calibration has failed, it means that the control to be calibrated has not reached the maximum and
minimum travel, or VR1 and VR2 has not been toggled to the middle position. The re-calibration is required.
4.5 Restoring Factory Settings
When you want to clear the data in the transmitter, you can restore all data in the transmitter to default values. That is,
all model data and settings are restored to the default state.
Please follow the steps below to restore factory settings:
1. Power on the transmitter, enter the system menu, and select the factory reset function. Follow the prompts to
press the OK button to start the reset.
2. After the successful reset, the system automatically returns and stays in the system menu interface. It indicates that
the system has been restored to the factory settings.
4.6 Power-o
Please follow the steps below to power o the system:
1. Power o the receiver.
2. Turn the switch to the OFF position to turn o the transmitter.
Caution
• When you shut down the system, make sure to power off the receiver, and then the
transmitter. Otherwise, the model may be damaged and people may be injured.
system operations and alarms. For system operations and alarms, you can enable/disable the sound separately or
collectively. In addition, you can set the sound volume separately.
Please follow the steps below to perform the settings:
1. Start the transmitter and enter the SYSTEM menu. In the SYSTEM settings, set the LED, SOUND, and VOLUME.
2. After the settings are completed, return back.
To Next Page
Loading...
Need help?
General
