To Next Page

To Previous Page

FS-G7P

Digital Proportional Radio Control System

Website

Danger • Do not use the battery if damaged.

Battery type: AA batteries or 2S lithium batteries JST interface inside the battery compartment.

Please follow the steps below to install the transmitter batteries：

1. Open the battery compartment cover.

2. Put 4 AA batteries with su󽗋cient electricity into the battery compartment. Ensure that the metal terminals on the

batteries contact the metal terminals inside the battery compartment.You should choose the proper size of 2S 7.4V

lithium battery to access the JST interface. Connect them correctly.

3. Cover the battery compartment.

3.2 Installing Receiver and Servo

Install the receiver and servo in the following methods:

3. Preparation

Prior to operations, please install the battery and connect devices according to the sequence and guide as

described in this chapter.

3.1 Installing Transmitter Battery

Danger

• Do not open, disassemble, or attempt to repair the battery.

Danger

• Only use speci󽗉ed battery (X4 AA batteries).

Danger

• Do not crush/puncture the battery, or short the external contacts.

Danger

• Do not drop the battery or expose to strong shocks or vibrations.

Danger

• Do not expose to excessive heat or liquids

Danger

• Always store the battery in a cool, dry place.

Steering servo

Throttle servo

AUX. servo

CH1

CH3

CH2

CH4

CH5

CH7

CH6

FlySky FS-G7P User Manual

Questions and Answers: