24 Operating Instructions Flytec 6005/6010
Maintenance and Care
Water Damage
Water damage invalidates the warantee. If the instrument gets wet, proceed as follows:
• remove the batteries immediately
• remove the housing screws and open the housing
• dry the instrument in warm air from a hair dryer
• If the instrument got wet in salt or contaminated water thoroughly rinse all interior
components with warm water before drying Send the instrument, as soon as
possible, to Flytec USA for customers in North America. Customers outside North
America should send their instrument to Flytec AG in Switzerland.
• Warning: NEVER dry the instrument in a microwave oven
Calibration
Altitude, temperature and airspeed can be corrected in their respective Option-Modes;
however, the correction values for these functions should only be altered for good reason
(i.e. you are sure that the displayed values are inaccurate). For information on calibration
contact Flytec AG at flytec@swissonline.ch or Flytec USA at info@flytec.com
Warranty
Our instruments carry a 24-month warranty. However, physical damage such as a broken
housing or display window as well as damage resulting from abuse, battery leakage and
water landings are excluded from this warranty
Disclaimer
Flytec AG and Flytec USA accept no liability for faults arising from any abuse or
unapproved use of your instrument. In rare cases, it may happen that the instrument does
not provide any data at all, or the data is incorrect. FLYTEC is not responsible for any
damages due to the incorrect functioning of the instrument.
Responsibility for ensuring safe flight lies with the pilot alone.
To Next Page
Loading...
