15
Test Strip
Test Strip Handle
Hold this part to
insert the test strip
into the slot.
Confirmation Window
This is where you confirm
if enough blood has been
applied to the absorbent
hole in the strip.
Contact Bars
Insert this end of the test
strip into the meter. Push
it in firmly until it will go
no further.
Absorbent Hole
Apply a drop of blood
here. The blood will be
automatically absorbed.
ATTENTION:
The front side of test strip should face up when
inserting test strip.
Test results might be wrong if the contact bar is not fully
inserted into the test slot.
NOTE:
The FORA D40 meter should only be used with FORA D40 Test Strips. Using
other test strips with this meter may produce inaccurate results.
To Next Page
Loading...
