EasyManua.ls Logo

Fora D40d - Performing a Blood Glucose Test

Fora D40d
120 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
NOTE:
• Choose a different spot each time you test. Repeated punctures at the same
spot may cause soreness and calluses.
• Please consult your health care professional before you begin AST.
• It is recommended that you discard the first drop of blood as it might contain
tissue fluid, which may affect the test result.
Blood from sites other than the
fingertip
Replace the lancing device cap with the
clear cap for AST. Pull the cocking control
back until it clicks. When lancing the
forearm, upper arm or hand, avoid lancing
the areas with obvious veins because of
excessive bleeding.
1
2
2. Select the appropriate measuring mode by pressing
For selecting the measurement mode, please refer to the FOUR
MEASURING MODES.
1. Insert the test strip to turn on the
meter
Wait for the meter to display and
.
3. Obtaining a blood sample
Use the pre-set lancing device to puncture
your desired site. After penetration,
discard the first drop of blood with a
Performing a Blood Glucose Test

Table of Contents

Related product manuals