F100 GHOST User Manual
11
PREFLIGHT CHECKLIST
1. Fly in an open area and abide by all local and federal guidelines. Check the FAA’s B4UFLY mobile app
for up-to-date drone flight info.
2. Make sure your drone and transmitter batteries are fully charged.
3. Put the left stick of the transmitter in the middle position.
4. Follow the Calibration instructions closely. Always turn ON your transmitter first before flying, and
turn OFF the drone first when you’re finished.
5. Make sure the connection is solid between your battery and motor; vibration may cause loosening.
6. Make sure the propellers are installed correctly and the motors are working normally after unlocking.
CALIBRATION
TRANSMITTER CALIBRATION
1. Turn on the transmitter.
2. Push down the Calibration button and hold for 3 seconds (Fig. 8).
3. Transmitter will beep 3 times, and drone indicator light will start flashing slower.
4. Rotate control sticks in any direction for 2 full rotations (Fig. 9).
5. Push the Calibration button and hold again for 3 seconds (Fig. 10).
6. Transmitter will beep 3 times, and drone indicator light will start flashing indicating calibration completion.
FIGURE 8 FIGURE 10
FIGURE 9
Both the drone and transmitter are calibrated when manufactured. However, calibration is
recommended before every use for optimal flight, and may be required after a crash or if the
drone is not operating properly.
To Next Page
Loading...
Need help?
General
