1
slide
pull up
SIDE VIEW
SEPARATE SLIDING TOP FRAME FROM THE BASE
Fully extend the BEDSLIDE® and remove the top frame by lifting up and out.
The welded safety stops must go up and over the rear roller bearings and spacer
guides in order for the top frame to release. This step will require 2 people to help lift!
2
9/19
BEDSLIDE.COM | 888.807.0099
TEAM LIFT
REQUIRED
INSTALLATION
REMOVE SPRAY IN LINER MATERIAL
If your bed is equipped with a spray in bed liner you must cut and remove the
material around the bed bolt. A 3 1/2” x 3 1/2” square is sufficient.
3 1/2”
3 1/2”
UTILITY KNIFE
To Next Page
Loading...
