1. Press the unlocking handle and
pull the floor rearwards a short
way.
2.
Lift up the rear of the floor (1).
3. Push the floor forwards until it
engages at the front (2).
4. Release the support leg from the
clip on the underside of the floor.
5. Insert the end into the square
retainer in the left-hand rail (3).
6. Lift the storage compartment
cover using the loop.
To return the loadspace floor to the
normal position:
1. Hold the floor with one hand and
release the support leg with the
other hand.
2. Insert the support leg back into
the clip.
3. Lower the floor.
4. Press the unlocking handle and
pull the floor slightly rearwards
until it drops into position on the
rails.
REAR UNDER FLOOR
STORAGE
To Next Page
Loading...
