If you switch autowipers on, the
wipers will not cycle until water is
detected on the windscreen. The rain
sensor will then continuously
measure the amount of water on the
windscreen and adjust the speed of
the wipers automatically.
RAIN SENSOR
High sensitivityA
Low sensitivityB
Adjust the sensitivity of the rain
sensor using the rotary control. If you
set the control to low sensitivity, the
wipers will operate when the sensor
detects a lot of water on the
windscreen. If you set the control to
high sensitivity, the wipers will
operate if the sensor detects a small
amount of water on the windscreen.
WINDSCREEN WASHERS
WARNING
Do not operate the windscreen
washers for more than 10
seconds or when the reservoir is
empty.
Note:
The washer jets are heated
when the ignition is on.
To Next Page
Loading...
