Format kappa 30 - Assembly; Sliding Table

Panel Saws
kappa 30/kappa 40
Panel Saw
Kappa 30 / kappa 40
Setup and installation
Fig. 27: Positioning the machine/Floor mounting
1. 


2. 


 
!
"
7.3 Assembly
7.3.1 Sliding table
Attention: Due to transport reasons, the sliding table, depending on its length, may be packaged separate-
ly. Two to three additional helpers, depending on the cutting length, are required to install the machine.



Fig. 28: Assembling the sliding table
1. 
2. 
3. 

!   #
" $

!
"

!
"
#
$