Format kappa 30 - Calibrating the Saw Blade Height Display; Red Light-Emitting Diode Fault Lights up

Panel Saw
Kappa 30 / kappa 40
Faults
11.12 Calibrate the saw blade height display
11.13 Red light-emitting diode „Problem“ lights up


 

 

!
Attention! Risk of material damage! Do not use detergents! Clean the speed detector with a dry cloth only.
Fig. 143: Speed detector
1. 

2. The saw blade must be selected according to the tooling!
50 mm
3. 
4. 

! 
" 
# 
$ 
% 

!
50 mm
" #
%
$
!
3 SEC