Format kappa 30 - Splitter; Loosening;Adjusting the Splitter; Assembling;Removing;Changing the Splitter

Panel Saw
Kappa 30 / kappa 40
Making adjustments and preparations
8.12 Splitter
8.14.1 Loosening/adjusting the splitter
Fig. 64: Adjusting the splitter
1. 
2. 
3. 

4. 

 


!  #
"  $
Attention! Minimum tightening torque: 20 Nm!
8.12.2 Assembling/removing/changing the splitter
Removing the splitter
1. 
2. 
3. 
!
"
Attention! Operation without the splitter is only allowed if dado tooling is used!
Attention! Minimum tightening torque: 20 Nm!
Fig. 65: Removing the splitter

!
"
#
$
!
"