Panel Saws
kappa 30/kappa 40
Panel Saw
Kappa 30 / kappa 40
Setup and installation
Warnung! Danger – electric current: Before hooking up the machine to the power supply, compare the
specifications on the data plate with those of the electrical network. Only hook up the machine if the two
sets of data correspond to each other. The electrical outlet must have the appropriate socket (for a three
phase alternating current motor, CEE).
1.
2.
3.
4.
Cross cut table and backup fuse
Mains voltage 230 ± 10% V
Mains voltage 400 ± 10% V
Warnung! Danger – electric current: Work on electrical fittings may only be carried out by qualified per-
sonnel and in strict observance of the safety instructions.
Attention: Do not open the switch box of the machine without the express consent of the Format-4 service
department. Violating this stipulation shall render the right to make claims under the warranty null and
void.
Characteristics of electrical connections:
7.5 Electrical connection
5.
6.
7.
!
"
#
Fig. 36: Potential-free contact
!
"
#"
!