Format kappa 30 - Changing the Saw Blade; Adjusting the Saw Blade Diameter

Panel Saw
Kappa 30 / kappa 40
Making adjustments and preparations
!
"
#
$
Fig. 58: Control panel
8.10.4 Adjusting the saw blade diameter




1. 


2. 

3. 

8.10.3 Changing the saw blade
Fig. 57: Changing the saw blade
! $
"  %
§  &
Attention! Minimum tightening torque: 20 Nm!

 
 
1. 
2. 
3. 
4. 


5. 
6. 

7. 


8. 


9. 

10. 
11.


12.


!
#
" $
!
"
§
$
%
&