Format kappa 30 - Correcting the Rip Fence Angle; Readjusting the Height of the Parallel Cutting Fence Guide

Panel Saw
Kappa 30 / kappa 40
11.9 Correcting the rip fence angle
Fig. 128: Angle
1. 

2. 
3. 
4. 
5. 
6. 
7. 
8. 
9. 
10.
!
"
#
11.10 Readjusting the height of the parallel cutting fence guide
Fig. 129: Readjusting the height of the parallel cutting fence guide
1. 

2. 
3. 
4. 
5. 
!
Faults

#
!
"
!