Format kappa 30 - Switching on the Machine

Panel Saw
Kappa 30 / kappa 40
9.2 Switching on the machine
1. 

!
Warning: Risk of injury due to insufficient preparation!
It is only permitted to switch on the machine if, for the work at hand, the required preconditions are
fulfilled and any preliminary work is completed. For this reason the instructions for adjusting, fitting and
operating (see the corresponding chapters) must be read before switching on the machine.
Fig. 89: Main switch
Fig. 90: Control panel
Operation
2. Circular saw:

3. Scoring unit:

"
§

!
#"
#"