Formlabs Form Cure - Introduction; Intended Use

10
2. Introduction
2.1 Intended Use
The Form Cure provides the light and heat necessary to post-cure 3D printed parts to their
optimal properties. The final performance characteristics of cured photopolymer resin may vary
according to your compliance with the instructions for use, application, operating conditions,
material combined with, end use, or other factors.
In some cases, the additive manufacturing process may inherently result in variable
performance characteristics between manufacturing runs or within a specific part.
Such variances may not be apparent and may result in unexpected defects in
additively fabricated parts.
You must independently verify the suitability of additive manufacturing,
stereolithography, Form Cure, and any specific designs or materials employed for the
application and intended purpose before use. In no event shall Formlabs be liable for
any loss, death, or bodily injury that you suer, or that you cause to any third party, in
connection with your use of Formlabs products. To the fullest extent legally permitted
Formlabs EXPRESSLY DISCLAIMS ANY IMPLIED OR EXPLICIT WARRANTY OF
FITNESS for a particular usage, the particular nature and circumstances of said usage
being unforeseen and unforeseeable to Formlabs.
Formlabs is not a manufacturer of medical devices. Formlabs provides tools and
materials that may be used in many applications, but makes no claims as to the safety
or eectiveness of any specific devices made using Formlabs products. Certain
Formlabs products, such as those commonly known in the industry as “biocompatible”
resins, have been engineered to comply with relevant industry standards. The specific
standards and most relevant technical specifications may be identified within the
technical data sheets and have been tested according to relevant testing protocols
for those standards and specifications. Biocompatible resins are a speciality product,
developed for use by medical professionals, and should be used in accordance with
their instructions for use.
Do not modify. The Form Cure is intended for use as-is. Modifying the unit without
explicit approval and directions from Formlabs will invalidate your warranty, and could
potentially ruin the machine and cause you bodily harm.
Never remove the bottom panel of the unit.
NOTICE
WARNING
WARNING
WARNING