Safety Warnings | 13
3. Safety Warnings
Read and understand this manual and its safety instructions before using the Form
Cure. Failure to do so can result in serious injury or death.
Supervise young or inexperienced users to ensure safe operation.
The instructions contain warnings and safety information, as explained below:
Danger indicates a hazard with a high level of risk which, if not avoided, will result in death
or serious injury.
Warning indicates a hazard with a medium level of risk which, if not avoided, could result in
death or serious injury.
Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor
or moderate injury.
Notice indicates information considered important, but not hazard-related.
HOT SURFACES: Do not touch hot surfaces.
3.1 Component and Subsystem Safety
3.1.1 Electronic Components
The Form Cure is a professional appliance that includes electronic components. As with any
such appliance:
• Do not operate the Form Cure with a damaged cord or plug.
• Always disconnect power before cleaning.
• Only use well-maintained equipment.
• Operate on a clear and level surface.
3.1.2 Hot Surfaces
The Form Cure contains a 100 W heater to help ensure parts are strong after post-curing.
While the heater and fan designs limit overheating and the heater is insulated to contain heat,
surfaces of the Form Cure and printed parts may be hot during and after use.
Do not touch hot surfaces.
Take care when removing parts from the Form Cure. The metal turntable can remain hot during
and after a cure cycle. Always allow the turntable to cool completely before touching or cleaning.
WARNING
DANGER
WARNING
CAUTION
NOTICE
WARNING
CAUTION
To Next Page
Loading...
