Formlabs Form Cure - Table of Contents

1. Table of Contents
1. Preface ..................................................................8
1.1 Read and Retain Instructions ................................................8
1.2 Obtaining Documentation and Information ...................................8
2. Introduction .............................................................10
2.1 Intended Use ............................................................10
2.2 Technical Specifications ....................................................11
2.3 Product Elements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
2.4 Form Cure Controls .......................................................12
3. Safety Warnings .........................................................13
3.1 Component and Subsystem Safety .........................................13
3.2 Personal Protective Equipment (PPE) .......................................15
3.3 Specifications of Tools to be Used .........................................15
4. Preparation and Setup ...................................................16
4.1 Arranging the Workspace .................................................16
4.2 Unboxing the Form Cure ..................................................16
4.3 Installing the Form Cure ...................................................16
4.4 Transporting Form Cure ...................................................17
5. Using the Form Cure .....................................................18
5.1 Operational Environment ..................................................18
5.2 Post-Curing ..............................................................18
5.3 Considerations for Specific Geometries .....................................19
5.4 Time and Temperature Settings ........................................... 20
5.5 Device Management ......................................................21
5.6 Emergency and Exceptional Situations. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
6. Maintenance ........................................................... 23
6.1 Inspecting the Product ................................................... 23
6.2 Inspection Tasks Between Post-Cure Cycles ............................... 23
6.3 Monthly Inspection and Maintenance Tasks ................................ 24
6.4 Periodic Inspection and Maintenance Tasks ................................ 24
6.5 Planned Maintenance Procedures ......................................... 24