10. Glossary
Circular wheel
mount
The turntable sits on the circular wheel mount, which is driven by the
motor assembly.
Cover The hinged cover allows access to the Form Cure turntable. Double walls
insulate the cure chamber and internal surfaces reflect light.
Display The display shows status, time, temperature, and options for configuring the
Form Cure.
Display ribbon
cable
A flat, flexible cable connects the display assembly to the motherboard.
Heater A 100 W heating module that can heat the chamber up to 80 °C / 176 °F .
Interlock magnets The interlock sensor detects these magnets to determine when the cover is
closed. This safety mechanism disables the heater, 405 nm LEDs, and turntable
when the cover is open.
Knob The knob is the primary interface device for the Form Cure. Turn the knob to
navigate the display menu. Press the knob to select a feature or setting.
LEDs An array of thirteen (13) 405 nm LEDs help to post-cure parts. Secondary lights
illuminate the turntable when the cover is open and during heating.
Motherboard The motherboard is the main circuitry through which all systems in the Form
Cure communicate.
Motor assembly The motor assembly rotates the turntable during the post-cure cycle.
Power supply Provides power to the Form Cure. Specifications: 24 V, 6 A
Turntable A rotating plate ensures balanced post-curing across all exposed part surfaces.
The turntable is perforated to allow light to reach all surfaces of printed parts in
the Form Cure.
USB port The Form Cure can connect to a computer via USB. The port is connected to the
motherboard and can be accessed from the back of the machine.
To Next Page
Loading...
