Formlabs Form Cure - Planned Maintenance Procedures

Maintenance | 25
6.5.1 Updating the Form Cure Firmware
Formlabs regularly releases updated firmware to fix bugs and improve functionality. Review
the PreForm and firmware release notes to learn more about the improvements that come
with each version’s release.
To update the firmware:
1.
Connect the Form Cure with a USB cable to a computer running the latest version of PreForm.
2. Locate and run the Form Wash/Cure Updater tool in the PreForm installation folder to check
for firmware updates and to update the firmware.
3. When the updater tool detects the unit, select Update Firmware.
4.
The tool uploads the new firmware and restarts the unit to complete the update. The update
should take approximately 20 seconds. The turntable may rotate during firmware updates.
Do not disconnect the USB or power cables during the update.
5. Firmware Up To Date appears next to the connected unit in the main updater window.
Select Done once the update is complete.
6. Repeat steps 1–5 to update firmware on additional Form Cure units.
7. Select Quit to close the updater.
NOTICE