FORST ST6 D42 - Weekly Checks -ST6

Date of check:
Individual (print name):
Individual (signature):
Weekly Checks –ST6
Check
Further action
✔/✘
Carry out all daily checks
☐
Blade condition
• Replace if required
☐
Flywheel main bearings
• Good general condition
• Free from damage
☐
☐
Main anvil condition
• Turn/replace if required
☐
Top feed roller assembly
• Remove debris if found
• All nuts and bolts secure
☐
☐
Feed roller motor mounts
• Secure and undamaged
☐
Side panels
• Behind panel is clear of debris – remove panel if
required
☐
Grease bearings
• 2 pumps of grease per grease nipple (if in a low
ambient temperate, grease with engine running
and feed rollers turning)
☐
Grease tow hitch assembly
• 2 pumps of grease at both grease nipples
☐
Electrical wiring
• Cables and conduit secure and undamaged
☐
Hydraulics
• Hoses secure
• All components free of leaks
☐
☐
Safety decals
• Decals are fitted and undamaged
☐
Bodywork
• Secure and undamaged
☐
Axle
• Wheel alignment
• Axle mount condition, both sides
• No wheel bearing freeplay
☐
☐
☐
Tyre and rim assembly
• Tyre tread depth – 1.6mm on central ¾ of tread
• Wheel bolts torqued to 100Nm
• Sidewall undamaged
• Rim undamaged
☐
☐
☐
☐
Service schedule
• Is machine due a service – see operator handbook
for schedule
☐
Lubricate moving parts
• Suitable lubricant to be used
☐
Tyre pressure
• 205/65R15C
• 1150kg-1170kg – 40psi
• 1240kg-1260kg – 45psi
• 1440kg-1460kg – 50psi
☐
Additional comments: