Getting started Front panel features
FortiGate-4000 Installation Guide 01-28004-0028-20040830 19
KVM switch module
Use the KVM switch module to switch serial connections to the CLI of each
FortiBlade-4010 module installed in the FortiGate-4000 chassis. To access the CLI,
connect the RJ-45 to DB-9 serial cable to the management module (see
“Management module” on page 22) and to a management PC. You can use the
FortiBlade select buttons on the KVM switch module to select the FortiBlade-4010
module that you can connect to.
Figure 5: KVM switch module front panel
Table 3: FortiBlade-4010 module front panel LEDs
LED State Description
PWR/KVM Blue The FortiBlade-4010 module is powered on.
Green KVM access to this FortiBlade-4010 module is enabled.
STATUS Off Normal operation.
Red System Fault.
LAN 1 Green The correct cable is connected to the internal interface of this
FortiBlade-4010 module and the connected equipment has power.
Flashing Network activity at the internal interface of this FortiBlade-4010
module.
LAN 2 Green The correct cable is connected to the external interface of this
FortiBlade-4010 module and the connected equipment has power.
Flashing Network activity at the external interface of this FortiBlade-4010
module.
Mounting Knot
ALARM
KVM
FortiBlade
select buttons
Not used
KVM
ALARM
Not used
To Next Page
Loading...
