NAT/Route mode installation Connecting the FortiGate unit to the network(s)
FortiGate-4000 Installation Guide 01-28004-0028-20040830 55
Starting the setup wizard
1 In the web-based manager, select Easy Setup Wizard.
Figure 24: Select the Easy Setup Wizard
2 Follow the instructions on the wizard pages and use the information that you gathered
in Table 15 on page 48 and Table 17 on page 54 to fill in the wizard fields.
3 Select the Next button to step through the wizard pages.
4 Confirm the configuration settings, and then select Finish and Close.
Reconnecting to the web-based manager
If you changed the IP address of the internal interface while you were using the setup
wizard, you must reconnect to the web-based manager using the new IP address.
Browse to https:// followed by the new IP address of the internal interface. The default
address of the internal interface is https://192.168.1.99.
The IP address of the out of band management interface is not changed from the
setup wizard. If you connected to the FortiGate unit using the out of band
management interface you do not have to reconnect after completing the wizard.
You are now finished the initial configuration of the FortiGate unit, and can proceed to
“Next steps” on page 56.
Connecting the FortiGate unit to the network(s)
After you complete the initial configuration, you can connect the FortiGate unit
between the internal network and the Internet.
• To connect the FortiGate-4000P, see “FortiGate-4000P network connections” on
page 28
• To connect the FortiGate-4000S, see “FortiGate-4000S network connections” on
page 29
Note: If you use the setup wizard to configure internal server settings, the FortiGate unit adds
port forwarding virtual IPs and firewall policies for each server. For example, for each server
located on the Internal network the FortiGate unit adds an External->Internal firewall policy.
To Next Page
Loading...
