Fortinet FortiGate FortiGate-4000 - 10;100 out of Band Management Module

Getting started Rear panel features
FortiGate-4000 Installation Guide 01-28004-0028-20040830 23
Figure 10: Management module
10/100 out of band management module
The 10/100 out of band management module provides dedicated ethernet connection
to manage each FortiBlade-4010 module installed in the FortiGate-4000 chassis. This
out of band connection is not shared by other network connections. The 10/100 out of
band management module contains two 10/100 ethernet interfaces that connect to
the management interface of each FortiBlade-4010 module.
Table 6: Management module controls
Button Description
On/Off switch Turns the management module on and off. The management
module must be turned on to establish a serial connection to
the CLI of each FortiBlade-4010 module.
ID dial Set to 0.
Console port Serial connection to the CLI of each FortiBlade-4010 module.
Table 7: KVM switch module LED
LED State Description
ERR Off Normal operation.
Yellow System fault. Contact Fortinet Technical Support.
On/Off switch
ERR LED
Console
port
ID dial
ONON OFFOFF
ERRERR
Mounting Knot
Mounting Knot
Not used
Not used
Note: You can connect to the LAN 1 connector or to the LAN 2 connector but not both.