Getting started Factory default configuration
FortiGate-4000 Installation Guide 01-28004-0028-20040830 39
Factory default firewall configuration
FortiGate firewall policies control how all traffic is processed by the FortiGate unit.
Until firewall policies are added, no traffic can be accepted by or pass through the
FortiGate unit. The factory default configuration contains one firewall policy. (Some do
not contain any firewall policies.) To allow traffic through the FortiGate unit you can
add firewall policies. See the FortiGate Administration Guide for information about
adding firewall policies.
The following firewall configuration settings are included in the default firewall
configuration to make it easier to add firewall policies.
Management IP
IP: 10.10.10.1
Netmask: 255.255.255.0
Management access
Internal HTTPS, Ping
External Ping
Out of Band Ping, HTTPS
Out of band
management
interface
IP: 172.16.1.2
Netmask: 255.255.255.0
Default Gateway: 172.16.1.1
Management Access: HTTPS, Ping
DNS
Primary DNS Server: 207.194.200.1
Secondary DNS Server: 207.194.200.129
Table 13: Factory default Transparent mode network configuration (Continued)
Table 14: Default firewall configuration
Configuration setting Name Description
Firewall address All Firewall address matches the source or destination
address of any packet.
Pre-defined service More than 50
predefined
services
Select from any of the 50 pre-defined services to
control traffic through the FortiGate unit that uses that
service.
Recurring schedule Always The recurring schedule is valid at any time.
Protection Profiles Strict, Scan,
Web,
Unfiltered
Control how the FortiGate unit applies virus
scanning, web content filtering, spam filtering, and
IPS.
Firewall policy n/a n/a
To Next Page
Loading...
