Statistics WAN Link Health Detection
Note that IP Pair and Web Service show at most 50 entries respectively.
WAN Link Health Detection
It shows WAN link health detection results regarding the reliability of a specific WAN connection. The data are derived
based on ping results from destination IP list configurations in [System] -> [WAN Link Health Detection]. It enables to
observe the number of sent requests, number of received responses, and the success ratio for a given destination.
These statistics assist administrators in further analyzing network status and user behavior.
WAN Link : The WAN link to be monitored.
Automatic Refresh : Time interval for refreshing tables.
Destination IP : The destination IP address to which ping requests will be sent.
Number of Requests : The number of requests sent to the destination IP so far.
Number of Replies : The number of ICMP responses received so far from the destination in WAN.
Success Ratio (%) : The percentage of responses divided by requests. The higher the percentage, the
greater the reliability.
Dynamic IP WAN Link
It shows dynamic IP WAN link details like its IP address obtained via PPPoE or DHCP. It also enables to create new IP
addresses by re-establishing connections to the WAN.
Re-Connect All : Reconnect all WAN links via PPPoE or DHCP.
Automatic Refresh : Time interval to refresh table results.
WAN : WAN connected by either PPPoE or DHCP.
IP Address : IP allocated to current WAN link.
Gateway : Gateway’s IP address for current WAN link.
Netmask : Sub network mask.
DNS : Dynamic DNS Server IP.
Connected Time : Duration of WAN connectivity.
Reconnect : Reconnect a WAN link via PPPoE or DHCP.
145 FortiWAN Handbook
Fortinet Technologies Inc.
To Next Page
Loading...
