Scope What's new
What's new
The following features are new or changed since FortiWAN 4.0.0:
FortiWAN 4.0.2
Bug fixes only. Please refer to FortiWAN 4.0.2 Release Notes.
FortiWAN 4.0.1
FortiWAN introduces new hardware platforms FortiWAN 1000B and FortiWAN 3000B, and new FortiWAN 4.0.1
firmware based on the AscenLink series of Link Load Balancing appliances already in the market. FortiWAN 4.0.1 is
substantially similar to AscenLink V7.2.3 with the additions noted below.
To assess the impact of deploying FortiWAN 4.0.1 on your network and processes, review the following new and
enhanced features.
l
Data Port Changes -
l FortiWAN 1000B supports 3 GE RJ45 ports and 4 GE SFP ports. Each port can be programmed
as WAN, LAN or DMZ. Redundant LAN and DMZ ports can be configured. 2-link LACP/LAG
LAN or DMZ ports can be configured. Default LAN port is Port 6 and default DMZ port is Port 7.
l FortiWAN 3000B supports 8 GE RJ45 ports, 8 GE SFP ports and 8 10GE SFP+ ports. Each port
can be programmed as WAN, LAN or DMZ. Redundant LAN and DMZ ports can be configured.
2-link LACP/LAG LAN or DMZ ports can be configured. Default LAN port is Port 11 and default
DMZ port is Port 12.
l
HA Configuration Synchronization - Two FortiWAN appliances can be connected in active-passive
High Availability mode via an Ethernet cable between the systems' HA RJ-45 ports. HA will not
interoperate between AscenLink and FortiWAN and will not interoperate between different FortiWAN
models or the same model with different Throughput licenses. Model and Throughput must match.
l
HDD - FWN 1000B and FWN 3000B add internal 1TB HDDs for Reports data storage.
l
Hardware Support - FortiWAN 4.0.1 for FortiWAN supports FortiWAN 200B and FortiWAN 1000B.
AscenLink series models are not supported. Note that FortiWAN 4.0.1 does not support FortiWAN
3000B, please look forward to the sequential releases.
FortiWAN 4.0.0
FortiWAN introduces new hardware platform FortiWAN 200B and new FortiWAN 4.0.0 firmware based on the
AscenLink series of Link Load Balancing appliances already in the market. FortiWAN 4.0.0 is substantially similar to
AscenLink V7.2.2 with the additions noted below.
To assess the impact of deploying FortiWAN 4.0.0 on your network and processes, review the following new and
enhanced features.
l
Data Port Changes - FortiWAN 200B supports 5 GE RJ45 ports. Each port can be programmed as
WAN, LAN or DMZ. Redundant LAN and DMZ ports can be configured. 2-link LACP/LAG LAN or DMZ
ports can be configured. Default LAN port is Port4 and default DMZ port is Port 5.
FortiWAN Handbook
Fortinet Technologies Inc.
12
To Next Page
Loading...
