Fortinet FortiWAN - Limitation in the IPSec deployment

Advanced Functions of Reports Appendix A: Default Values
Appendix A: Default Values
In console, enter the command ‘resetconfig’, or on the Web UI select “Factory Default” to do a hard reset and restore
all settings to factory default.
Users cannot change the console’s default account and password. The default username and password is
“Administrator“and ”fortiwan“respectively.
When restored to factory default, the Web UI accounts and passwords will also be reset to:
Administrator 1234
Monitor 5678
The Web UI login port will be restored to the default port 443.
FortiWAN also supports SSH logins. The interface for SSH login is the same as the console with identical username
and password.
WAN Link Health Detection Default Values
l System default values contain 13 fixed servers IPs for health detection.
l Values for all Port Speed and Duplex Settings will also be reset.
l All ports are restored back to AUTO state.
Network default Values (FortiWAN 200B)
Port 1: WAN
l WAN Link: 1
l IP: 192.168.1.1
l Netmask : 255.255.255.0
l IP in DMZ 192.168.1.2~192.168.1.253
l Default Gateway 192.168.1.254
l DMZ at Port 5
Port 2: WAN
l WANLink: 2
l IP: 192.168.2.1
l Netmask: 255.255.255.0
l IP in DMZ 192.168.2.2~192.168.2.253
l Default Gateway 192.168.2.254
l DMZ at Port 5
FortiWAN Handbook
Fortinet Technologies Inc.
180