Configuring Network Interface (Network Setting) How to set up your FortiWAN
Note: FortiWAN assumes that IP addresses that are unlisted in [IP(s) on Localhost] are all in WAN.
[Basic Subnet]: Subnet in DMZ
This topology is frequently found where cluster hosts in IPv4 private subnet are located on the DMZ. In this example,
FortiWAN port5 has been mapped to DMZ port, with private IP 192.168.4.254. And subnet 192.168.4.X is located on
the DMZ as a whole. From UI, select [Subnet in DMZ] from [Subnet Type] in [Basic Subnet].
Check [Enable DHCP] if hosts in the subnet in DMZ require DHCP service. And enter the starting and ending address
in [DHCP Range]. If any host in the subnet uses static IP address, then in [Static Mapping], enter its IP and MAC
FortiWAN Handbook
Fortinet Technologies Inc.
54
To Next Page
Loading...
