To enable motion detection, follow the steps below:
1 Enable Detection Switch
2 Sensitivity---- It supports three modes: Low, Middle and High. The higher the sensitivity, the camera will be
more easily alarmed. Select one motion sensitivity.
3 Trigger Interval----The interval time between two motion detections. Here supports
5s/6s/7s/8s/9s/10s/11s/12s/13s/14s/15s. Select one interval time.
4 Snap Interval---- The interval time between two pictures.
5 Select the alarm indicators
There are some alarm indicators:
A Camera Sound
If you select Camera Sound, when the motion has been detected, the people around the Camera will hear
beep alarm sound, if the device is connected with the audio output device.
B PC Sound
If you select PC Sound, when the motion has been detected, the people around the PC will hear beep alarm
sound.
To Next Page
Loading...
