5.2.6 Reset Button and Transmitter LED
In the event the sensor array is not transmitting, reset the sensor array.
With an open ended paperclip, press and hold the RESET BUTTON for
three seconds to completely discharge the voltage.
Figure 11
.
lectro-Magnetic Interference (EMI). Keep the console several feet
communication.
rated at 300 feet line of
100 feet maximum under most real-world installations, which
s through metal
5.3 Best Practices for Wireless Communication
Note: To insure proper communication, mount the remote sensor(s)
upright on a vertical surface, such as a wall. Do not lay the sensor flat
Wireless communication is susceptible to interference, distance, walls
and metal barriers. We recommend the following best practices for
trouble free wireless communication.
E
away from computer monitors and TVs.
Radio Frequency Interference (RFI). If you have other 433 MHz
devices and communication is intermittent, try turning off these other
ices for troubleshooting purposes. You may need to relocate the dev
transmitters or receivers to avoid intermittent
1. Line of Sight Rating. This device is
sight (no interference, barriers or walls) but typically you will get
include passing through barriers or walls.
2. Metal Barriers. Radio frequency will not pas
11
To Next Page
Loading...