5.2 Sensor Set Up
1. Wind Vane
2. Wind Speed Sensor
3. UV sensor/ Light sensor
4. Thermo-hygro sensor
5. Rain collector
6. Bubble level
7. Solar panel
8. U-Bolt
partment
r 4s if the unit power up. Then the LED will
ds (the sensor transmission update period).
bolts and mounting pole
he U-bolts, which are in turn used to mount the sensor
n a pole, requires installation of an included metal plate to
The metal plate, visible in Figure 1, has four
ch the ends of the two U-Bolts will fit. The plate itself is
urved profile (which will end up “hugging” the mounting pole). Once the
e U-Bolts and insert both
9. Battery com
10. Reset button
11. LED Indicator: light on fo
flash once every 16 secon
5.2.1. Install U-
Installation
package o
of t
receive the U-bolt ends.
holes through whi
inserted in a groove on the bottom of the unit (opposite side of solar
panel). Note that one side of the plate has a straight edge (which goes
to the groove), the other side is bent at a 90-degree angle and has a in
c
metal plate is inserted, remove nuts from th
U-bolts through the respective holes of the metal plate as shown in
Figure 8.
6
To Next Page
Loading...