32
Creating an event memory
1. At the desired position while the VF-16 is stopped or
during playback, press the [HOLD/>] key.
The time when pressing the [HOLD/>] key is held on the
screen.
1. Press the [REWIND/PREV] key while holding down the
[SHIFT] key to skip back to the previous event memory
point.
2. Press the [F FWD/NEXT] key while holding down the
[SHIFT] key to skip advance to the next event memory
point.
Skip locate
With the Skip locate function using the event memo-
ries, the unit automatically recognizes the locate point
and locate there.
When the Skip locate is executed, the locate point is
shown on the screen and you will know where the
current position goes.
Locating an event memory
You can store up to 99 event memory points (00 to 99). These are used for the “Skip locate” function, as well as
for the Scene event map described later in “Chapter 3. Advanced mixer operations.”
Viewing the event memories
1. Press the [SCENE-STORE/MAP] key while holding down
the [SHIFT] key.
The display shows the event number select screen for the
scene event map, in which you can view and check the
event memories created by the procedure above.
The unit for event memories - ABS, Bar/Beat/Clk or MTC
- depends on the time base setting.
<Hint>
Event memory numbers are assigned in ascending or-
der of ABS time, regardless of order in which event
memories are created.
For example, if you create event memories in order as
shown in the upper diagram below, the event memory
numbers are assigned as shown in the lower diagram.
EVT 03
07M30S
EVT 02
05M00S
EVT 01
02M30S
ABS0
EVT 07
17M30S
EVT 06
15M00S
EVT 05
12M30S
EVT 04
12M30S
<Hint>
You can delete unnecessary event memories. See “Edit-
ing the event map” in “Advanced mixer operations” de-
scribed later for details.
2. Rotate the [JOG] dial to scroll through the event memory
list.
3. After viewing the screen, press the [EXIT/NO] key.
The display returns to the Normal display.
07M30S05M00S02M30S
ABS0
17M30S15M00S12M30S
12M30S
2
3
6
7
1
5
4
2. Press the [STORE] key.
The key lights up (in red) and “Hit Any Memory Keys!”
appears on the screen.
3. Press the [LOCATE/EVT MEM] key while holding down
the [SHIFT] key.
“Entry EVT**” (where ** shows the number) appears for
a short time, while the time held in step 1 is entered in
the event memory.
Current position
EVT 03
07M30S
EVT 02
05M00S
EVT 01
02M30S
ABS0
EVT 06
17M30S
EVT 05
15M00S
EVT 04
12M30S
[SHIFT] key + [REWIND] key
[SHIFT] key + [F FWD] key
10M00S
To Next Page
Loading...
Need help?
Inputs and Outputs
