36
3
Integrated Peripherals
► OnChip IDE Devices / OnBoard Devices / SuperIO Devices / USB Devices Setting
Press <Enter> to go to relative submenu.
OnChip IDE Devices
► IDE HDD Block Mode
If your IDE hard drive supports block mode, select [Enabled] for automatic detection of the
optimal number of block read/write per sector.
► IDE DMA Transfer Access
[Disabled] : to disable DMA transfers for all IDE drives. They will revert to PIO mode transfers.
[Enabled] : to enable DMA transfers for all IDE drives. The proper DMA mode will be detected
at boot-up. If the drive does not support DMA transfers, then it will use PIO mode instead.
Recommend leaving this BIOS feature at the default [Enabled] setting. You should only disable
it for troubleshooting purposes. For example, certain IDE devices may not run properly using
Phoenix - AwardBIOS CMOS Setup Utility
Integrated Peripherals
► OnChip IDE Devices [Press Enter] Item Help
► OnBoard Devices [Press Enter]
► SuperIO Devices [Press Enter] Menu Level ►
► USB Devices Setting [Press Enter]
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F7: Optimi�ed Defaults
Press Enter
Phoenix - AwardBIOS CMOS Setup Utility
OnChip IDE Devices
IDE HDD Block Mode [Enabled] Item Help
IDE DMA Transfer Access [Enabled]
On-Chip Primary PCI IDE [Enabled] Menu Level ►
IDE Primary Master PIO [Auto]
IDE Primary Slave PIO [Auto] If your IDE hard drive
IDE Primary Master UDMA [Auto] supports block mode
IDE Primary Slave UDMA [Auto] select Enabled for
automatic detection of
** On-Chip Serial ATA Setting ** the optimal number of
SATA Controller [Enhanced Mode] block read/writes per
SATA Port Speed SettingsSATA Port Speed Settings [Disabled] sector the drive can
PATA IDE Mode Primary support.
SATA Port SATA3,4 is Sencondary
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F7: Optimi�ed Defaults
Enabled
To Next Page
Loading...
