3
35
Integrated Peripherals
► IDE Configuration/OnBoard Configuration/SuperIO Configuration/USB Configuration
Press <Enter> to go to relative submenu.
IDE Conguration
► SATA Controller
This item allows you to select the mode of the SATA ports. Setting values are: [Disabled],
[Compatible], [Enhanced].
► Configure SATA Channels
This item allows you to congure the location of SATA ports in "System Information" menu.
Setting values are: [Before PATA] and [Behind PATA]. When set to [Before PATA], SATA drives
are displayed as Primary IDE Master/Slave and Secondary IDE Master/Slave in "System
Information" menu; when set to [Behind PATA], SATA drives are displayed as Secondary IDESATA drives are displayed as Secondary IDE
Master/Slave and Third IDE Master/Slave in "System Information" menu.
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
Integrated Peripherals
► IDE Conguration► IDE Conguration [Press Enter] Help Item
► OnBoard Conguration► OnBoard Conguration [Press Enter]
► SuperIO Conguration► SuperIO Conguration [Press Enter] Congure the IDE
► USB Conguration► USB Conguration [Press Enter] device(s) .
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Press Enter]
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
IDE Conguration
IDE Conguration Help Item
SATA Controller [Enhanced]
Congure SATA Channels [Before PATA]
Disabled
Compatible
Enhanced
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Enhanced]
Options
To Next Page
Loading...
Need help?
General
