22 | P a g e
AUTO-V will begin its volume adjustment cycle as soon as you begin playing a
sound. You will also see the AV indicator on the top line of the TX-505 screen
show ON.
Turning AUTO-V Off
AUTO-V can be turned off at any point during operation. When AUTO-V is
disengaged, the FURY 2 will continue playing the current sound at 65% of the
maximum volume to help prevent an erratic volume level change.
1) Hold down the selector knob for 2-3 seconds to access the main menu.
2) Select FURY 2 CONTROL
3) Select AUTO-V OFF to disengage AUTO-V
4) Exit the menu
Setting the Maximum Volume Level
AUTO-V will climb to volume level 30 as a maximum across a three minute
period by default. You can change the maximum volume level for the climb by
using the volume up/down buttons on the transmitter once you have engaged
AUTO-V.
Note: Making changes to the volume level after AUTO-V has been
engaged for a while can result in erratic volume level changes. Get
familiar with how AUTO-V works before using it on a stand.
Note: If the FURY 2 is turned off, be sure to reselect AUTO-V function
prior to operation.
6.11 AUX
This button is used to operate an external device that is connected to the FURY
2—typically the FOXPRO
®
Jack-in-the-Box Decoy. Depressing the AUX button
will begin operation of the external device. A second press of the AUX button
will cease operation. For more information on the AUX function, see the AUX
Jack Function in the beginning of the manual.
The AUX can be configured to be momentary or a latched output. This can be
useful if you are using external devices that must see a latched connection as
opposed to the momentary connection required to activate/deactivate
FOXPRO
®
’s Jack-in-the-Box Decoy.
Adjusting AUX Jack Operation
1) Access the main menu by pressing and holding the rotary selector
knob for about 2-3 seconds.
2) Highlight the TX505 CONFIG menu item and press the rotary selector
knob one time.
To Next Page
Loading...
