31 | P a g e
8.3 PROGRAMMING WITH THE UTILITY
To gain access to the FURY2’s USB port
1. Remove the battery compartment door from the back side of the
FURY2 and remove the batteries. The USB port will be accessible
through the bottom of the battery compartment.
2. Connect a USB cable between this port, and the USB port on your
computer. Once the connection is made, your computer should
recognize the FURY2 as a removable drive.
NOTE: The USB cable is not provided with the FURY2. You will need a USB 2.0 A/B
cable. This is often referred to as a “USB printer cable”.
Programming Process
1. Open the FOXPRO Programmer. The shortcut for the utility is located
in your Start menu under “All Programs” and then “FOXPRO”. After
clicking on the shortcut, you will be reminded to back your sounds.
2. Click OK, you will then be taken to the programming utility.
3. On the upper-right of the screen, locate “Select Device”. Use the drop-
down menu to select the appropriate letter for your FURY2.
NOTE: The drive letter varies on different computers. Once you have
selected the correct drive letter, the list of sounds currently on your FURY2
appears in the right vertical column labeled “Caller Sound Files”. You will
now notice that a new button appears above the Select Device window that
reads “Backup”. If you have not made a backup of your sounds, simply click
on this button. The programmer by default will backup your sounds to a
“FOXPRO” folder, and a sub folder “Backup”. This is also a good folder to
use to add new sounds prior to adding sounds, or reprogramming your
FURY2. You can also create sub folders for different species, if you choose,
rather than to have all sounds located in one folder. Once your backup is
complete, you are ready to reprogram your FURY2.
4. Select the “source” folder of your new sounds (located on the left hand
side of the programmer screen). This is the folder where your sounds
are located. By default, the FOXPRO Programmer will access the
C:\FOXPRO\Sounds folder. If this is not the folder that your sounds
are located in, select the proper folder by using the directory selector
on the far left side of the screen.
5. Once the proper folder is selected, the sounds will appear in the left
side column, called “Source Sound Files”.
6. Now, determine the position that you would like to add new sounds to
your FURY2. For example, if you would like to add the Jackrabbit
Distress to your FURY2, highlight that sound in the left side column.
NOTE: If this sound does not have a three digit number and a space
To Next Page
Loading...
