Adaptation changes baseline settings. You should refer to the Service Manual for your particular
car before attempting to use the Adaptation function. However, many available Adaptation
Channels are totally undocumented!
To set an adaptation:
1. Select Adaptation from Function Menu and press the ENTER key.
Figure 4-48 Sample Function Menu Screen
2. Input a channel number. If a channel exists, the actual adaptation value is displayed. If a
channel does not exist, a “not supported!” message displays. Use the function key Next or
Previous to scroll through all 255 possible channels.
Figure 4-49 Sample Channel No. Screen
3. Enter a new value and press the function key Set new value. The controller will temporarily use
the new value so you can evaluate its effect.
Figure 4-50 Sample Set New Value Screen
To Next Page
Loading...
