● Pending Codes
Diagnostic trouble codes stored in a control module are used to help identify the cause of a
trouble or troubles with a vehicle. These codes have occurred a specific number of times and
indicate a problem that requires repair.
Pending codes are also referred to as maturing codes that indicate intermittent faults. If the fault
does not occur within a certain number of drive cycles (depending on vehicle), the code clears
from memory. If a fault occurs a specific number of times, the code matures into a DTC and the
MIL illuminates or blinks.
To read codes/pending codes from a vehicle:
1. Scroll with the arrow keys to highlight Read Codes from Diagnostic Menu and press the
ENTER key.
Figure 5-3 Sample Diagnostic Menu Screen
2. Select Stored Codes/Pending Codes and press the ENTER key to confirm. A code list
including code number and its description displays.
Figure 5-4 Sample Read Codes Screen
If no DTCs are present the message “No (Pending) Codes Found!” is displayed. If any
manufacturer specific or enhanced codes detected, select vehicle a make before viewing DTC
information.
To Next Page
Loading...