STEEL RACKS Slide the racks onto the runners on both sides of the oven. The racks have non-tip
safety notches, which prevent them from being pulled out completely while the oven
is in use.
When inserting a rack, always check that the safety notches are at the back. To
remove racks, raise them upwards and pull out.
TELESCOPIC RACKS The oven is also equipped with full-extension telescopic racks that extend on ball
bearing glides. The telescopic racks must be securely fastened to the side runners.
Additional racks can be purchased as accessory (part # 901267).
To change shelf position:
- extract the rack out of the oven
- lift the rack to disengage the runners
- pull the rack out of the oven cavity
- close the rack
- install the rack in another position while completely closed
To Next Page
Loading...
