© Safe Fleet | September 2018 | All rights reserved
Document #: XE-SNB1-Install-PM-R0A
p. 18
inView 360 Fusion Installation Guide
Installing Video Components
For smaller vehicles like cars and vans, mounting the camera high on each side can sometimes result in undesired
shadows from the mirrors� In these cases, you might need to lower the cameras below the mirror line�
In a vehicle with a at front prole (like a re truck or transit bus), mounting it high and center is (often) optimal.
Ultimately, as long as the camera can see the ground (on all sides of the vehicle) without obstruction, then it’s in a
good mounting location �
Keep in mind that large bumpers or accessories like snow plows and winches can obstruct the camera view. This is
why its important to always soft-mount and calibrate before securing the cameras� If there’s an obstruction, move
the camera and calibrate again to see if the obstruction disappears from the image�
Be careful of bumpers
obstructing the camera
Camera mounted high
and center, with clear
view of the ground
To Next Page
Loading...
Need help?
General
