EasyManua.ls Logo

FRC inView 360 Fusion

Default Icon
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© Safe Fleet | September 2018 | All rights reserved
Document #: XE-SNB1-Install-PM-R0A
p. 20
inView 360 Fusion Installation Guide
Installing Video Components
Test and Calibrate
Once you’ve installed the cameras, you’ll need to do a nal function test to ensure that the installation was successful.
1� Power up the system and verify that the monitor turns on�
2� Using the driver button, cycle between the different camera views. Each time you click the button, the view
should change� You should have views for the following:
360 + Front
360 + Right
360 + Rear
360 + Left
Full Front
Full Rear
3� Repeat calibration if there are issues with the images�

Related product manuals