To Next Page

To Previous Page

Document #: XE-SNB1-Install-PM-R0A

p. 19

inView 360 Fusion Installation Guide

Installing Video Components

Once you’ve determined your camera mounting locations, hold the cameras in position (with tape or temporary adhesive),

and perform a calibration� To learn about the calibration process, download a copy of the inView 360 Calibration Guide

from the FRC inView 360 Fusion website page. (Please see the links on the left side of this website page for both the

Installation and Calibration guides�)

Hard-Mounting Cameras

If you’re happy with the calibration images, then you can begin hard-mounting the cameras to the vehicle� To do this:

1� Use the supplied camera drill templates to mark the drill holes. Ensure that the template is placed in the right direction.

2� Drill the holes and remove the template�

3� Feed the camera cord through the center hole�

4� Remove the adhesive from the back of the camera bracket and place it on the vehicle surface. Align to the drilled

holes�

5� Remove the adhesive on the camera lens�

6� Place the cover over the camera�

7� Fasten the cover to the vehicle with the two black screws.

8� Cover the screws with the black round adhesive screw covers.

9� Seal the camera base with waterproof caulk.

10� Inside the vehicle, connect the camera to the extension cable, then to the appropriate connector on the video

harness�

11� Repeat for each camera�

Screw Cover

FRC inView 360 Fusion User Manual

Questions and Answers: