© Safe Fleet | September 2018 | All rights reserved
Document #: XE-SNB1-Install-PM-R0A
p. 5
inView 360 Fusion Installation Guide
Recommended Tools
Monitor Components
1x Monitor
1x Monitor
Base
1x Monitor
Adhesive Pad
Video Cable
(attached to
monitor)
1x Remote
(NOT USED)
Recommended Tools
The following is a list of recommended tools for installing the inView 360-Fusion:
• Multimeter
• Electrical tape
• Soldering iron and solder
• Cordless Drill
• Phillips screwdrivers
• Phillips drill attachments
• Wire cutters
• Zip ties
• 1/8”, 1/16” Drill bits
• 3/4” Stepbit (Unibit)
• Crimpers
• Wire sh tape
To Next Page
Loading...