FRC inView 360 Fusion

© Safe Fleet | September 2018 | All rights reserved
Document #: XE-SNB1-Install-PM-R0A
p. 8
inView 360 Fusion Installation Guide
ECU Installation
ECU Installation Requirements
Ventilation
• Install the ECU away from any sort of heat outlet, heater, or AC blower�
• Do not operate the ECU in a closed-in area or restrict ventilation in any way� The ECU requires air circulation to
maintain optimum operating temperature and provide best performance�
• Do not expose the ECU to moisture�
Secure Surfaces
• Do not mount the ECU to a plastic panel or other surface that cannot support the ECU’s weight or is subject to
constant vibration�
Mounting Orientation
• The ECU can be installed horizontally, vertically, or upside down�
Clearance Around the ECU and (optional) DVR
• Allow sufcient clearance: at least 6” in front of the ECU and 2” on each side for removal of the security front
cover and easy access to the hard drive and USB ports�
• Allow sufcient clearance behind the DVR for power, signal, and camera cables.
Power, Signal & Camera Cables
• Provide enough slack on the power cable to prevent any force from being exerted on the connectors.
• A single 4-inch diameter loop is sufcient.
• Avoid right angle bends in the Ethernet cables�