WALKING BELT AND DECK LUBRICATION
The treadmill is equipped with lubricated running board, which needs regular maintenance. The friction
between running board and running belt has a great effect on the treadmills’ life.
a) Remove the power cord from the wall socket.
b) Wipe any the dust between running board and running belt with a clean cloth.
c) As shown in the picture apply the Silicon oil on the running board (2 small daubs about 50mm in
diameter approximately where your feet hit the deck during use).
d) Plug the treadmill back and set running to the lowest speed. Slowly walk the silicon over the surface of
the treadmill deck.
DO NOT OVER TIGHTEN the walking belt.
This can cause reduced motor performance and excessive
roller bearing wear.
TO CENTER WALKING BELT:
•
Make sure the treadmill is on a level surface
•
Run the treadmill at approximately 4km/hr.
•
If the belt has drifted to the right, turn the right adjusting bolt 1/2 turn clockwise and the left
adjusting bolt 1/2 a turn counterclockwise.
•
If the belt has drifted to the left, turn the left adjusting bolt 1/2 turn clockwise and the right
adjusting bolt 1/2 turn clockwise and the right adjusting bolt 1/2 turn counterclockwise.
•
Stand on the side rail and push the walking belt back to the centre carefully with your foot and
once
Picture A If the belts has drifted to the RIGHT
Picture
B If
the belts has drifted to the LEFT
WARNING: ALWAYS UNPLUG THE TREADMILL FROM THE ELECTRICAL OUTLET BEFORE
CLEANING OR SERVICING THE UNIT.
PIC A
PIC B
To Next Page
Loading...
